I have 3D printed my own 12" snare pad to replace the 8" snare pad on my Alesis Nitro Mesh kit.

However, the pad is way too sensitive and most of the head shots are being picked up as rim shots. After some research I realised I needed resistors connected to the piezos. So, I opened up the existing 8" snare pad to look at the connections inside and it looks like this...

There appear to be 150k resistors inbetween ground and the tip or ring and 120k (head) and 68k (rim) resistors between positive and tip/ring. I think the circuit is like this....

Does this look right to you folks?
Thanks,
Mike