Hi guys I need some help here. I think I have broken something
I was updating the rom, I use to have the blueJays but decided to go back to stock.
I turn the module on, usb connected and pressing REC. Selected the syx file and when flashing it says 'checksum error'.
I tried a few more times, then I decided use a different USB cable and ----here is when I fuk'd up--- I turn the module OFF and replaced the usb cable.
After that, it doesnt boot anymore:
I press 'on' button then the displays blinks one or two times and it doesnt boot, it just stays there with its 5 leds on
any idea?
thanks in advance
Turning off during updating never ends well.Alesis warns about doing that.
See if The module will respond to a factory reset.
There are two ways to reset the DM10:
With the DM10 module powered off, press and hold the EXIT and STORE buttons.
While holding the EXIT and STORE buttons, power the unit on.
Once the screen says SYSTEM REINIT, release the EXIT and STORE buttons
To reset only the kits, sequences, or trigger settings:
Press UTILITY to enter the main Utility Menu.
Press SYS (F4) to access the Accompaniment Settings.
Press INIT (F2) to access the reinitialization page.
Use CURSOR UP/DOWN to move through the following menu items:
All Kits: All of the module’s kits and their settings will return to factory default
All Sequences: All of the module’s sequences and their settings will return to factory default
All Trigger Settings: All of the module’s trigger settings will return to factory default
Highlight the option you would like to reset, then press EXEC (F4).
A window will appear asking you to confirm your choice. To confirm and reinitialize the selected settings, press YES (F1). To Cancel, press CANCEL (F2 or F2).
https://www.alesis.com/kb/article/1560