Hmm...bad news...
But thanks for the reply.
It would be much more cheaper in that way.
I don't know what you mean by cheaper....unless you don't have or want to purchase a (2) cable ride..
If you want to use (2) cymbals you can set the RIDE to Dual Zone MODE and use a Dual Zone cymbal in RIDE1 input (Bell is on EDGE) ..and a single zone cymbal in the RIDE2/PERC1 input and assign Voices to it
To do this:
1.Press EXT TRIG to enter the main Ext. Trig Menu page.
2.Select the ride's bow or bell by pressing NOTE CHASE then striking that zone on your cymbal trigger.Alternatively, you can highlight the trigger name at the top of the screen using the CURSOR UP / DOWN buttons to highlight it and use the VALUE UP / DOWN buttons or VALUE DIAL to select either "RideBell" or "RideBow."
3.Press MODE (F4).
4.Use VALUE UP / DOWN buttons or the VALUE DIAL to select "2 Zones" if your ride cymbal is a dual-zone or "3 Zones" if your ride cymbal is a three-zone.
5.When you have finished making your edits, you can press EXIT or any button that will enter another screen (e.g., DRUM KIT, UTILITY, etc. Your edits will remain for that session (i.e., until you turn off the module)
DON'T FORGET TO "STORE" your settings..or you'll lose them
To store Ext. Trig settings:
1.Be sure you are in the Ext. Trig Menu by pressing EXT TRIG.
2.Press STORE.
3.A window will appear asking you to confirm your choice.
Press CANCEL (F2 or F3) to cancel storing your Ext. Trig settings.
Press YES (F1) to store them.
EDIT: Added Link
DM10 Drum Module Manual Rev CMODE (RIDE BOW & BELL) pg 26