I'm in Canada and recently purchased the Strata Core kit. So far, I am loving it. However as those of you who have the kit know, managing the cables is a bit challenging. I just set up a solution that worked pretty well for me, so I thought I'd share. The method I used is:
- First I ran the cable to each component in the sequence and order that they would come off the harness, using the velcro cable ties to hold them in order along the horizonal bars, leaving enough slack to adjust the components if needed.
- Starting from the right (floor tom in my case), I started coiling the spiral cable wrap around the cables, working towards the module, keeping the cables aligned (not crossing them) and exiting the cables from the wrap to each component. I used the velcro cable ties to hold the spiral cable wrap to the bars.
- Once close to the module, I coiled the excess cable into loops and secured using a velcro storage strap (Wrap-It) hanging under the module.
- I used some mic stand clips on the cymbal stands to keep the cymbal wires in place.
- I also found a tablet holder for my iPad that worked pretty well and installed it on the horizontal cross bar next to the module.
The stuff I used is below:
Spiral cable wrap:
https://www.amazon.ca/dp/B07JPG2672Mic stand cable clips:
https://www.amazon.ca/dp/B0DD77F8JGWrap-It velcro storage strap:
https://www.amazon.ca/Wrap-Heavy-Duty-Storage-Straps-Variety/dp/B06Y5Q4VZDTable mount:
https://www.amazon.ca/dp/B0BN1PKDGTI've attached some photos.
