Are there any settings which must be done in the module to enable the usb port?
I have connected the module to my ipad, using the (working) usb connection which I previously used on my Crimson 2SE module, Melodics would immediately recognize the module and support it. But with the Strike module Melodics does not show any connected device and when I try manual config it says ?no midi device found??
Am I missing something or did I get a module with a broken usb port?
Which Version iOS?..I show the STRIKE Module working in iOS 15.2..but only using a Camera Kit with Power connected to the Camera Kit..
The settings in Utility should be set to the Standard Drum Channel 10.
The Crimson II SE (Medeli DD650) Modules have a default MIDI Channel of 10..which is the Standard Channel for drums...
The STRIKE Module is different..the Main MIDI Channel is OMNI and each Voice has individual MIDI Channels with the Default MIDI Channel 1...(Standard Channel for Keyboards).
You'll need to go into each Voice and set the MIDI Channel to 10..
The easiest way is to select the default User Kit...assign all the Voice MIDI Channels to 10 and make sure the MIDI Notes are also assigned for Melodics then save/name it as Melodics Kit...You'll then have a Kit preset specifically for Melodics.
The MIDI Channel/Notes assignments apply to both Incoming and Outgoing MIDI.
EDIT:I checked Melodics as I haven't been there in quite awhile..but I see they finally added support for the STRIKE Pro..but I can't tell you which lessons
(if any) support the extra Kit pieces