Author Topic: Question about Nitro mesh kit  (Read 1596 times)

Question about Nitro mesh kit
« on: October 03, 2018, 12:29:11 PM »
Just purchased and set up yesterday. The ride symbol seems to rest at an awkward angle with relation to the stand it's on. I probably would need to snap a pic later when i'm home because it's hard to explain.

Was just wondering if it's normal or maybe i goofed in the installation somehow. Everything works fine so it isn't a huge deal.

Thanks,
Dan

Re: Question about Nitro mesh kit
« Reply #1 on: December 28, 2018, 07:59:35 AM »
The stands only have one tilt. I have a surge kit and the stands are tricky to get adjusted right. You can buy standard stands to use that have the arm and two adjustable angles. However, the mount will not fit the 7/8 shaft. You will have to drill out the mount like I did. Also the anti spin cymbal mount will need to be move over. This again will not fit right. Either buy one, or mod it to fit.
I feel that positioning (ergo-dynamics) is very important, but it is a preference.

You can try rotating the shaft 180 to set the angle joint or even flip the mount to place the main shaft in front of the rack.

Maybe someone with more experience can chime in.