Hello everyone, My 1st strike kit would not trigger edge hits on any of the cymbals. So I just received an entire new kit from the shop... And the cymbals do the same on the 2nd kit! Can someone confirm the bow and edge hits on a cymbal should show up separately on the module. See video... Edge and bow both register as bow on the module ? This affects hihat and ride too.
https://youtu.be/EDYU82harCg
Your impatient..this is a forum not social media 3 posts in 3 hours for the same problem isn't going to get a faster answer..
The STRIKE kits don't just work straight out of the box (contrary to ALesis"Optimzed") and I have never heard of all edges on every input not working.Most of the problems are incorrect settings I don't have the Strike cymbals..I am using my own builds..the 6 sec video doesn't give me much information other than the sensitivity is high and you don't have to hit very hard to get the bow to work...most complaints I have heard/read on STRIKE cymbals is you have to really hit the edge hard..tapping it doesn't do much..
If you want to check functionality of the edge..
select a kit... 001 Rockn'kit..it has a pretty loud crash
select Crash 1
under Trigger..check setting is it piezo or switch..edge is normally switch
press [Voice] select Crash 1 Bow..set the level to 0FF
Under [Voice]..select Crash 1 edge..(make sure a voice is assigned to it)...set the level to 99
press [Velocity]..set to it to 0
The Bow should now be off...and the edge is isolated...strike the edge..do you see it light up on the module or hear anything at all...
Isolate/Test each cymbal and if they all fail ..then it's probably the module